Stylesheet ../dokuwiki/css/_search.css not found, using ../dokuwiki/css/_search.less instead. Please contact developer of "altronic" template.
Stylesheet ../dokuwiki/css/_admin.css not found, using ../dokuwiki/css/_admin.less instead. Please contact developer of "altronic" template.
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
documents:afr-500:afr500operating [2022/04/05 10:59] rocky [2.3 Interface options] |
documents:afr-500:afr500operating [2023/03/09 11:22] (current) rocky [13. THERMOCOUPLE ALARMS] |
||
|---|---|---|---|
| Line 482: | Line 482: | ||
| {{: | {{: | ||
| - | Jumper | + | Jumper |
| Auxiliary Mode is indicated by a BLUE LED located below the Altronic P/N on the label | Auxiliary Mode is indicated by a BLUE LED located below the Altronic P/N on the label | ||
| {{: | {{: | ||
| Line 543: | Line 543: | ||
| * Non-latching registers that when mapped to the AWI appear as an LED and turn off after the fault condition has cleared | * Non-latching registers that when mapped to the AWI appear as an LED and turn off after the fault condition has cleared | ||
| * Latching registers that when mapped to the AWI will appear as an LED and stay on even after the thermocouple is no longer in the fault condition | * Latching registers that when mapped to the AWI will appear as an LED and stay on even after the thermocouple is no longer in the fault condition | ||
| - | * A digital output signal attached to Digital Output 1 that latches on a fault condition | + | * A digital output signal attached to LS Digital Output 1 that latches on a fault condition |
| To clear all of the alarms, regardless of a single or dual bank system, there is one ALARM ACKNOWLEDGE register. | To clear all of the alarms, regardless of a single or dual bank system, there is one ALARM ACKNOWLEDGE register. | ||