Differences

This shows you the differences between two versions of the page.

--- documents:ngi-5000-logic:ngi5000operating [2023/02/28 10:19]
rocky [8. SELECTION OF GLOABL TIMING MODES]
+++ documents:ngi-5000-logic:ngi5000operating [2023/02/28 10:23] (current)
rocky [8. SELECTION OF GLOABL TIMING MODES]
@@ Line 152: / Line 152: @@
 {{ :documents:ngi-5000-logic:one_step_retard.jpg?300|}}
+selection can increase or decrease the one-step retard value. The default
+configuration selects one step retard to be controlled by the Misc Input terminal. The
+additional retard would be implemented when the input is grounded.
 ----
 {{ :documents:ngi-5000-logic:rpm_retard.jpg?300|}}
+e selection can enable or disable the pre-configured retard curve controlled
+internally by engine RPM.
 ----
 {{ :documents:ngi-5000-logic:4-20.jpg?300|}}
+selection can enable or disable the pre-configured retard curve controlled by
+the 4-20 mA current loop input. The choices are ON and OFF,
 ----
 {{ :documents:ngi-5000-logic:serial_retard.jpg?300|}}
+selection can enable or disable the additional retard value controlled by the
+serial port.
 ===== - SETUP CONTROL OPTIONS =====
 {{ :documents:ngi-5000-logic:energy_level.jpg?300|}}